21st Century Neck Turning Tool Lathe with Cutter, Case Holder and Driver

                           TURNING ARBORS AND EXPANDER MANDRELS SOLD 

                         SEPARATELY NOT INCLUDED WITH LATHE PURCHASE.

This is the first in the series of 21st Century Shooting Case Preparation. A modular system, all parts interchange. So if you have our Neck Turning Tool or Bracket everything will fit.
The floating design of our neck turner and case driver allows the case mouth (bore) to run on the arbor absolutely concentric. Therefore allowing O.D. to be turned concentric with I.D.  
The tail-stock creates a horizontal inline support for the base of the case. Also allows the operator to keep both hands on the power screw driver or drill. This makes it very easy to control feed rate of the cutting operation, generating a very fine turned finish.
Case holder drivers are designed to be the most gentle driver, yet providing an adequate hold. DOES NOT DRIVE OFF THE PRIMER POCKET - NO PRIMER POCKET OR CASE DAMAGE.
There are counter sunk mounting holes in the base plate for mounting.
     Driver shaft is hexed to use power screw driver or drill. 
     Tail-stock base is adjustable to accommodate cases from 17 Fireball to a .416 Rigby.  

Chart with specific calibers and required accessories: https://21stcenturyinnovation.com/chart